Canon imageRUNNER 2420 Trouble Error Codes List page 17

clock error
Lower tray ascent/descent motor
E542-
error (Finisher-Q3/ Q4
0003
Area error
Paddle error (Finisher-S1)
The paddle home position sensor
E577-
does not go on within 1.5 sec when
8001
the paddle is shifted to home
position.
Paddle error (Finisher-S1)
The paddle home position sensor
E577-
does not go off within 1.0 sec when
8002
the paddle is moved to home
position.
Shutter unit error (Finisher-Q3/ Q4)
E584-
The shutter open sensor does not go
0001
off (i.e., the shutter does not close).
Shutter unit error (Finisher-Q3/ Q4)
E584-
The shutter open sensor does not go
0002
on (i.e., the shutter does not open).
Punch motor error
E590- The punching home position is not
0001 detected even when the puncher
motor has been driven for 20 msec.
Code Description
Punch motor error
The punch home position sensor is
E590-
not defected even after the motor
0002
has stopped at time of punch
motor initial operation.
Punch dust sensor error
E591-
Error in light-receiving voltage
0001
while light is emitted
Punch dust sensor error
E591-
Error in light-receiving voltage
0002
while light is not emitted
Paper trailing edge sensor/
horizontal sensor error
E592-
Error in light-receiving voltage
0001
when light is emitted (trailing edge
sensor)
E592- paper trailing edge sensor/
17
Replace the No. 2 tray shift area sensor PCB.
Replace the finisher controller PCB.
Check the paddle motor. Check the paddle home
position sensor. Replace the finisher controller
PCB.
Check the paddle motor. Check the paddle home
position sensor. Replace the finisher controller
PCB.
Check the stack edging motor. Check the open/
close clutch. Check the shutter home position
sensor. Replace the finisher controller PCB.
Check the stack edging motor. Check the open/
close clutch. Check the shutter home position
sensor. Replace the finisher controller PCB.
Check the punch motor. Check the punch motor
clock sensor. Check the punch driver PCB.
Replace the finisher controller PCB.
Remedy
Check the punch motor. Check the punch motor
clock sensor. Check the punch driver PCB.
Replace the finisher controller PCB.
Check the waste paper case full sensor. Check the
punch driver PCB. Replace the finisher controller
PCB.
Check the waste paper case full sensor. Check the
punch driver PCB. Replace the finisher controller
PCB.
Check the paper trailing edge sensor. Check the
horizontal registration sensor. Check the punch
driver PCB. Replace the finisher controller PCB.
Check the paper trailing edge sensor. Check the