Graphic Equalizer (Geq); Setting The Frequency And Gain - Yamaha EMX7 Owner's Manual

Graphic Equalizer (GEQ)

The EMX7 is equipped with a Flex9GEQ
graphic equalizer. The Flex9GEQ allows you to
select up to nine bands out of a total of 31 and
adjust the gain.
Setting the Frequency and
Gain
1.
Call up the GEQ EDIT screen.
Press the corresponding AUX1, AUX2 or STEREO [GEQ
ACCESS] button for the channel that you wish to apply the
graphic equalizer.
NOTE
If another screen is being displayed, press the appropriate
[GEQ ACCESS] button until the GEQ EDIT screen comes up.
[GEQ ACCESS] button
GEQ EDIT screen
q w
q Frequency
This shows the frequency of the currently selected band.
(Unit: Hz)
w Gain
This displays the gain value of the currently selected band.
(Unit: dB)
e Graphical representation
This illustrates the current settings.
r Number of available bands
Since the EMX7 uses a Flex9GEQ graphic equalizer (with
maximum of 9 bands), this shows the number of remaining
bands that can be set.
2.
Select the frequency.
When the frequency value is highlighted, turn the [MENU/
CONTROL] rotary encoder to select the desired frequency
(for adjusting the gain).
NOTE
When the frequency value is not highlighted, press the
[MENU/CONTROL] rotary encoder to highlight it, and enable
frequency selection.
3.
Set the gain.
Press the [MENU/CONTROL] rotary encoder to highlight
the Gain parameter and enable setting of the gain value for
the frequency previously selected in Step 2. Turn the
[MENU/CONTROL] rotary encoder to set the gain for the
corresponding frequency.
e
r
4.
If necessary, repeat Steps 2 and 3 until the
graphic equalizer has been set as needed.
 Resetting the Gain for the Selected
Frequency
Press and hold down the [MENU/CONTROL] rotary encoder
for at least two seconds to reset the gain to "0.0" for the selected
frequency.
NOTE
Both the frequencies and the gain can be reset using the [MENU/
CONTROL] rotary encoder.
19
EMX7 Owner's Manual