Make sure the power LED is on (not blinking).
1
Press the WPS button for more than three seconds and release it. Press the WPS button on another
2
WPS-enabled device within range of the NBG6815.
Note: You must activate WPS in the NBG6815 and in another wireless device within two
minutes of each other.
For more information on using WPS, see
1.7 LEDs
Figure 1 Front Panel
The following table describes the front panel LEDs.
Table 1 Front Panel LEDs
LED
Power/System
Chapter 1 Introduction
Internet
WAN
Power
WLAN 5G
COLOR
STATUS
DESCRIPTION
White
On
The NBG6815 is receiving power and functioning properly.
Blinking
The NBG6815 is in the process of starting up, default restoring,
or My ZyXEL Cloud Server online registration pairing.
Off
The NBG6815 is not receiving power.
NBG6815 User's Guide
Section 8.2 on page
WLAN 2.4G
WPS
12
48.
USB