Ignition Modes - Volvo XC90 Owner's Manual

Hide thumbs Also See for XC90:
Table of Contents

Advertisement

Inserting and removing the remote key
Ignition slot with remote key and START/STOP
ENGINE button.
Inserting the remote key
Holding the end of the remote key with the
base of the key blade, insert the remote key
into the ignition slot as shown in the illustration
and press it in as far as possible (past the
detent).
CAUTION
Foreign objects in the ignition slot can
impair function or damage the lock.
Removing the remote key
The remote key can be removed from the igni-
tion slot by pulling it out.

Ignition modes

The various ignition modes are accessed with
the remote key in the ignition slot.
Posi-
Function
tion
0
Odometer, clock and tempera-
ture gauge are illuminated. Steer-
ing lock is deactivated. The audio
system can be used.
I
Laminated panoramic roof,
power windows,12-volt sockets,
navigation system*, climate sys-
tem blower, ECC, windshield
wipers can be used.
II
The headlights come on. Warn-
ing/indicator lights come on for
5 seconds. All equipment oper-
ates apart from heated seats and
rear window defroster, which
only work when the engine is run-
ning.
III
The starter motor will operate
until the engine has started.
NOTE
The brake pedal must not be depressed
when accessing ignition modes I or II.
I n f o r m a t i o n P r o v i d e d b y :
03 Your driving environment
Ignition mode 0
±
Insert the remote key in the ignition slot and
press it in as far as possible.
Ignition mode I
±
With the remote key fully pressed into the
ignition slot, press START/STOP
ENGINE briefly.
Ignition mode II
±
With the remote key fully pressed into the
ignition slot, press START/STOP
ENGINE for approximately 2 seconds.
Ignition mode III (engine start)
Start the engine, see page 109.
Stopping the engine
±
Press START/STOP ENGINE. (If the
engine is running and the vehicle is mov-
ing, keep the button depressed until the
engine stops).
Returning to ignition mode 0
±
Press START/STOP ENGINE briefly to
return to ignition mode 0 from modes I or
II.
Emergency towing
Ignition mode II should be used so that the
lighting can be switched on.
*
Option/accessory, for more information, see Introduction.

Ignition modes

03
81

Advertisement

Table of Contents
loading

Table of Contents