Adding A Function Code; Select Or Edit Source; Defining Sources - Nuvo Grand Concerto NV-I8GMS Installation Manual

2.6 Adding a Function Code

If a required IR code is not in the list of codes, it is possible
to add a code to the list by clicking the "Create New" button.
The pull-down menu contains a list of all standard IR codes.
A name not found in the list can be typed in, but it is
recommended that you use the names provided in the list.
This conserves memory in the Grand Concerto. Clicking on
the "OK" button proceeds directly to the IR recording
process.
2.6 Adding a Function Code
2.7 Cleaning Up an IR Library
Unused IR codes can be deleted from the list by highlighting
the code and either clicking the "Delete" button or right-
clicking and selecting "Delete. "
When you are finished editing the library, select "Done. "

3. Defining Sources

The "Sources" tab allows you to define the source
component attached to each of the six source inputs. All six
sources are not needed, but at least one source must be
defined.

3.1 Select or Edit Source

Double-clicking on a blank source will open the "Select
Source" window. This window assigns the appropriate source
number input. The "Display Name" is the text that will be
read on the Display Pad when that source is selected in any
zone. The display name can contain only capital letters,
numbers, and some punctuation. If an invalid key is typed, it
will be ignored.
The "Make" field defines the manufacturer of the
equipment. A drop-down menu allows you to choose a
source from the IR Library. The "Model" field provides a
drop-down menu that allows you to choose the specific
piece of source equipment from the selected manufacturer.
An important feature of the "Select Source" window is the
"Gain" level control. Different pieces of source equipment
tend to have different levels of audio output signal. This
slider control allows you to compensate for equipment that
has an inherently lower volume level. By using this
adjustment, when switching between sources, relative
volume levels remain constant.
When the appropriate information has been completed, click
"OK. " This will add the updated source information to the
"Source" window. When all the desired sources have been
defined, go to "Next" and proceed to the "Macros" setup.
3.1 Select or Edit Source
15