Connecting To The Mains Supply; Setting Up The Device - Grundig Sonoclock 691 DAB+ Manual

POWER­SUPPLY/INSTALLATION
Connecting­to­the­mains­supply
Note:
Check that the mains voltage on the type
7
plate (on the bottom of the device) corre-
sponds to your local mains supply. If this is
not the case, contact your specialist dealer.
1 P lug the power cable into the socket (230 V ~ ,
50/60 Hz).
Caution:
The device is connected to the mains with the
7
power cable. Pull out the power cable when
you want to disconnect the device from the
mains.
Make sure the power plug is easily acces-
7
sible during operation and not hindered by
other objects.
­-------------------------------------------------
Setting­up­the­device
The speaker of the device is located at the bottom
of the device. To optimise the sound, mount the
device holder on the bottom of the device.
1 C lick the device holder in place in the recesses
on the bottom of the device.
Mounting­ the­ device­ under­ the­
cabinet
The fixing screws can be found in the side com-
partment of the packing.
1 M ark the locations for four mounting screws.
2 Screw the device holder under the cabinet with
four screws.
3 I nsert the device in the holder.
Note:­
T o remove the device, press the snap-catch
7
at the back and remove by pulling forwards.
VOL.
VOL.
ENGLISH
19­ ­