Fisher & Paykel WashSmart Installation Instructions And User Manual page 15

Press POWER to activate your washer.
1
Select your wash cycle by turning the SmartTouch™ Control Dial.
2
Choose your wash options, if you wish to select options different from the default options for
3
the cycle.
Touch START / PAUSE to start the cycle.
4
If you make an invalid selection the washer will beep at you.
■ ■
When the cycle finishes, your washer will perform end of cycle beeps to alert you and then turn
■ ■
off automatically.
If you wish to stop your washer at any point during a cycle, simply touch START / PAUSE to pause
the cycle. There may be a slight delay while the drum comes to a stop, then the door will unlock.
In certain conditions however the door will remain locked for safety reasons (refer to page 15).
If you wish to cancel or change the wash cycle once a cycle has started, touch the START / PAUSE
button then select the new cycle. Touch START / PAUSE to restart the washer.
Important!
For the best fabric and colour care, remove your clothes as soon as the cycle has finished.
■ ■
Failure to follow the advice in this guide may result in damage to your garments and your
■ ■
expectations of wash performance may not be met.
3
Getting started quickly
4
EN
13