Table of Contents
Advertisement
Connection
Caution:
• ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY (UL 1310/CSA 223) or LIMITED
POWER SOURCE (IEC/EN/UL/CSA 60950-1).
• A READILY ACCESSIBLE DISCONNECT DEVICE SHALL BE INCORPORATED TO THE
EQUIPMENT POWERED BY 12 V DC POWER SUPPLY.
Before starting the connection, turn off the power of this camera and the devices to be connected.
Check and prepare the required devices and cables for connection.
Note:
• Since the connector storage section does not
have a sufficient space, use a LAN cable that do
not exceed the sizes described in the illustrations.
z
Remove the sub cover.
Open the screw covers x2 of the camera with a thin tool* as illustrated. Loosen the sub cover
fixing screws x2 using the bit for tamperproof screw (accessory), then remove the sub cover.
* A slotted head screwdriver etc.
IMPORTANT:
• Do not use excessive force when removing the sub cover. Failure to observe this may dam-
age the sub cover.
Screw covers
Sub cover
Sub cover
fixing screw
9 mm
{11/32 inches}
Example of LAN cable connector
23
Advertisement
Table of Contents
