White Outdoor 90G series Operator's Manual page 26

5. To place the new belt, begin by routing the belt around the
6. Then route the belt around the two deck idler pulleys as
Retighten the belt keeper rod loosened earlier.
8. Remount the belt guards removed earlier.
Reinstall the deck as follows:
a. With the deck beneath the mower frame, attach the
b.
c.
S 7— S
ECTION ERVICE
Cutting Blades
Shut the engine off and remove
ignition key before removing the cutting blade(s) for
using heavy gloves when grasping the blade
struck a foreign object. Do not operate the machine
until damaged components are replaced.
To remove the blades, proceed as follows.
1. Remove the deck from beneath the tractor, (refer to
Cutting Deck Removal earlier in this section) then gently
flip the deck over to expose its underside.
2.
baffle and the cutting blade to act as a stabilizer.
3. Remove the hex flange nut that secures the blade to the
To properly sharpen the cutting blades, remove equal
amounts of metal from both ends of the blades along the
cutting edges, parallel to the trailing edge, at a 25°- 30°
If the cutting edge of the blade has
previously been sharpened, or if any metal
separation is present, replace the blades with new
ones.
excessive vibration, may cause damage to the
tractor and/or result in personal injury.
5.
metal from the heavy side until it balances evenly.
NOTE: When replacing the blade, be sure to install the
a part number stamped in it) facing the ground when the
mower is in the operating position.