Panasonic KX-TDA50 Feature Manual page 238

1.13 P
[Example Network]
1001 (busy)
Monitor
extension
Extn. 2001
Extn. 2002
Extn. 4001
[Programming Procedure]
1.
Routing Table Assignment
TIE Line Routing and Modification tables must have been programmed in advance for all PBXs in the
network, to allow calls to be made and transferred between PBXs (→ 1.13.13 PRIVATE NETWORK
FEATURES).
In the programming example that follows, the PBXs in the network use the Extension Number method,
as shown in the illustration above. However, the PBX Access Code method can also be used.
2.
Network PBX ID Assignment
Assign a Network PBX ID to each PBX in the network.
→ 2.15.2 [9-2] Network Data Transmission—Network BLF Data Transmission for Centralized Operator
Feature—Network PBX ID
• IDs 1-8: Can monitor extensions at other PBXs, and transmit monitor data about local extensions.
Each ID number can be assigned to one PBX within the network.
• ID 0: Retransmits monitor data throughout the network. This ID number can be assigned to multiple
PBXs.
3.
QSIG Port Setting [Monitored PBX]
ISDN-QSIG (PBX Direct Connection)
Each QSIG port of a PRI card that will be used to transmit extension status information must be set to
do so through system programming. Even if a port is set to not transmit information, it will still receive
information from other PBXs.
→ 2.7.14 [1-1] Slot—PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—CO Setting—Networking
Data Transfer
Transmit
Enabled
Disabled
238 Feature Manual
PBX-1
Network ID 1
PBX-3
Network ID 0
Extension Status Information Functions
• Transmit information on own PBX extensions
• Receive information from other PBXs; forward it to other QSIG ports of the
PBX
• Re-transmit information received by other QSIG ports of the PBX
• Receive information from other PBXs; forward it to other QSIG ports of the
PBX
2001 (busy)
PBX-2
Network ID 2
2002 (idle)
4001 (idle)
PBX-4
Network ID 3
Monitor extension
Extn. 1001
Extn. 2002