Kärcher T 15/1 Service Manual page 6

5.4 Remove plugin
1 Power switch
2 Cable plug
3 Socket
4 Capacitor
Remove the plugin using a small screwdriver.
Pull the plugin out of the shaft and disconnect the cable plug.
5.5 Exhaust filter and bypass filter
1 Bypass filter for engine cooling air
2 Exhaust filter
3 Housing for exhaust filter
4 Nameplate
6
English 5.906-447.0 Rev. 00 (03/08)
5.6 Replace the turbine
1 Sound proofing
2 Upper turbine bearing
3 Sound proofing
4 Fastening clips for sound proofing (4 x)
5 Power switch
Note: The marking arrows (see circles) show the correct installa-
tion position of the upper turbine bearing.
1 Connection plug of the turbine
2 Turbine
3 Upper turbine bearing
Remove the upper turbine bearing from the turbine.
Pull the connection plug off the turbine.
Replace the turbine.
Note: When inserting the new turbine, the installation position
must be observed. The turbine must be installed so that the upper
turbine bearing is placed according to the marking arrows (see cir-
cles).