Basic Settings And Service Procedures - Kärcher T 15/1 Service Manual

5

Basic settings and service procedures

5.1 Replacing the impeller
1 Impeller with plugin axle
2 Fastening screw
Loosen the fastening screw.
Pull impeller with plugin axle out to the side.
Install the new impeller by reversing the installation steps.
5.2 Replace motor protection filter
1 Seal
2 Motor filter
3 Grid of the motor proction filter
Push the grids of the motor protection filter down, turn and re-
move.
Remove the motor protection filter.
Insert the new motor protection filter.
Insert the grid of the motor protection filter and lock it into place.
5.3 Replacing the mains cable
1 Power cord
2 Fastening screw for mains cable
3 Fastening screw for turbine housing
4 Cable guide
5 Clamping ridge for mains cable
6 Spring
7 Power switch
8 Fastening screw for bow
9 Bow
10 Turbine casing
Remove spring.
Unscrew the fastening screws for the mains cable.
Unscrew the fastening screws for the bow.
Remove the bow.
1 Opening at suction head
2 Power cord
3 Power switch
4 Capacitor
Pull the appliance switch out toward the top.
Replace the mains cable.
Note: Prior to installing the new mains cable, it must be pulled off
through the opening on the suction head.
Note: When installing the mains cable, the routing must be correct.
There are cable guides in the turbine housing, along which the ca-
ble must be routed. The cable must be pressed into the clamping
ridge to attach it.
English 5.906-447.0 Rev. 00 (03/08)
5