Nortel 3050 Installation Manual page 19

6. To continue using the portable, press r.
Measuring RSSI for a C3020 (Canada only)
The Receive Signal Strength Indicator (RSSI) is a
measurement of the signal strength the Base Station receives
from the portable. The Base Station controls the power
transmitting mode of the portable. When the Base Station
receives a weak signal, it instructs the portable to transmit in
high-power. When the Base Station receives a strong signal, it
instructs the portable to transmit in low-power. The strongest
RSSI value the portable displays is -44 dBm. The weakest
RSSI value the portable displays is approximately -85 to -95
dBm.
Measuring undirected RSSI
You may want to measure the Receive Signal Strength
Indicator between a portable and a Base Station radio.
1. Press L. Wait for dial tone.
2. Press *. Enter the feature code: 8 9 8.
The display shows the radio ID of the Base Station to
which the portable is linked, followed by the signal
strength, for example 03121 - 67. In this example, the
module is "03," the port is "12," and the radio is "1." The
signal strength is "-67dBm."
3. Read your measurement. Hand-off occurs normally.
4. To end the connection, press ror close the flap.
P0881594 Issue 02
Registering individual portables / 107
Receive Signal Strength Indicator overrides
normal display.
You cannot receive calls while measuring
Receive Signal Strength Indicator.
MICS-XC Norstar-Companion Installer Guide