Where To Go Next - Nortel 114200-E Installation And Operating

8.
Note: After connecting the ARN to the network, you can replace the
management console connection with a modem connection to enable remote
dial-in access.

Where to Go Next

Use the following table to determine where you want to go next.
For information about
Operating the ARN
Configuring the ARN for Netboot and
Directed Netboot
Using Local Boot (the Quick-Start Procedure)
ARN Technical Specifications
114200-E Rev 00
Entering stops the Quick-Start script and returns you to the Technician
n
interface prompt. Entering
When the install script completes, the ARN starts bridging and routing traffic.
Ensure that the ARN is successfully connected to your network.
To verify that the ARN is now connected to the network, contact your network
administrator. To troubleshoot any problems, your network administrator can
refer to Configuring Passport Remote Access.
If you need additional assistance, contact your local Nortel Networks
Technical Solutions Center.
allows you to configure another module/port.
y
Go to
Chapter 3
Appendix A
Appendix B
Appendix C
Starting the ARN
2-15