Page 468 of 544
Physical description
553-3011-100
Standard 14.00
NTAK10 2.0 Mb DTI card
•
software-selectable digital pads on a per channel basis
•
frame alignment and multiframe alignment detection
•
frame and multiframe pattern generation
•
CRC-4 transmission and reception (software selectable)
•
card status and alarm indication with faceplate-mounted LEDs
•
Periodic Pulse Metering (PPM) counting
•
outpulsing of digits on any of the abcd bits
•
Card-LAN for maintenance communications
•
per-channel and all-channel loopback capabilities for near-end and far-
end
•
self-test
•
download of incoming abcd validation times from software
•
warm SYSLOAD (TS16 AS16 transmitted)
Applicability to France
Features specific to DTI requirements for France are implemented in
firmware, and are switch-accessed. The requirements met are as follows:
•
transmission and reception of alarm indication signaling (AIS) in TS16
(card disabled, warm SYSLOAD, etc.)
•
France-specific PPM counting
•
decadic dialing
•
France-specific alarm report and error handling
The 2Mb DTI pack uses a standard IPE-sized (9.5" by 12.5"), multilayer
printed circuit board. The faceplate is 7/8" wide and contain six LEDs.
January 2002