Table of Contents
Advertisement
Page 378 of 544
Functional description
Trunk types supported
553-3011-100
Standard 14.00
NT8D14 Universal Trunk Card
Recorded Announcement operation . .. . . . . . . . . . . . . . . . . . . . . . . . . . . 386
Paging operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 387
The Universal Trunk Card:
•
allows trunk type to be configured on a per unit basis
•
indicates status during an automatic or manual self-test
•
provides card-identification for auto configuration, and to determine the
serial number and firmware level of the card
•
converts transmission signals from analog-to-digital/digital-to-analog
•
operates in A-Law or µ-Law companding modes on a per unit basis
•
provides software selected terminating impedance (600, 900, or 1200
ohm) on a per unit basis (1200 ohm supported for RAN trunks only)
•
provides software selected balance impedance (600 ohm or complex
impedance network) on a per unit basis
•
interfaces eight PCM signals to one DS-30X timeslot in A10 format
•
transmits and receives SSD signaling messages over a DS-30X signaling
channel in A10 format
•
supports PCM signal loopback to DS-30X for diagnostic purposes.
The Universal Trunk Card has eight identical units. You configure the trunk
type of each unit independently in the Trunk Data Block (LD 14). The card
supports the following types of trunks:
•
Central Office (CO), Foreign Exchange (FX), and Wide Area Telephone
Service (WATS)
•
Direct Inward Dial (DID) and Direct Outward Dial (DOD)
•
Tie Two-way Dial Repeating (DR) and Two-way Outgoing Automatic
Incoming Dial (OAID)
•
Paging (PAG)
January 2002
Hide quick links:
Advertisement
Chapters
Table of Contents
