Removing A Gbic - Nortel 312865-A Installation Manual

2 Verify that the GBIC is the correct model for your network
configuration
3 Remove the dust cover from the GBIC's optical bores.
Grasp the GBIC between your thumb and forefinger.
4
Insert the GBIC into the slot on the front panel of the Gigabit
5
Ethernet switching module
Figure 3 Inserting the GBIC into the switching module
Note:

Removing a GBIC

This section lists the steps for removing a GBIC.
To remove a GBIC:
1 Disconnect the network fiber cable from the GBIC
connector.
(Table 1 on page
GBICs are keyed to prevent incorrect insertion.
4).
(Figure 3) .
6