Volume Adjustment; Audible Beep Confirmation; Resetting The System - Jensen VX3014 Operation Manual

Mute
Press the rotary control on the front panel or press the [MUTE] button on
the remote control to mute the volume from the unit. Press again to un-mute.

Volume Adjustment

Volume Increase/Decrease
To increase or decrease the volume level, turn the rotary control on the
front panel. When the volume level reaches "0" or "40", a beep sounds,
indicating that the adjustment limit has been reached. The screen displays the
volume level for 2 seconds.
Programmable Turn-On Volume
To set the Turn-On Volume, rotate the rotary control (Volume control) to the
desired volume level, then press and hold the rotary control while the volume
bar is shown on the screen.

Audible Beep Confirmation

An audible beep tone confirms each function selection. The beep tone can
be disabled through the Setup menu.

Resetting the System

Soft Reset - To correct a system halt or other illegal operation, use the tip of a pen
to press and release the Reset button located just below the Eject button.
For a Hard Reset - Go to "Settings" > DVD tab > Load Factory > Reset. After a "System
Reset", the unit will restore all default settings.
Change Aspect Ratio (DVD / AV In Sources Only)
Press the [WIDE] button on the remote control to adjust the aspect ratio.
Image Settings (DVD / AV In Sources Only)
1. Enter image setting mode by pressing the [PIC] Button on the remote control.
2. Select the item to be adjusted and touch the Left or Right direction icons
[ ]/[ ] on the user interface to adjust the value.
3. To exit image setting mode, press the [PIC] Button on the remote control again
or simply stop making adjustments.
[RESET] Button
System Reset Button