Nortel 2332 Series Quick Installation page 85

1
Use the mounting template to cut a hole for the CAT-5 Ethernet cable.
2
Install the T-bar clamp that fits the T-bar.
T-bar
T-bar clamp halves
23.9-mm (15/16 inch) or 14.2-mm (9/16 inch) T-bar
(The clamps are different widths but the assembly is the same.)
3
Remove the mounting bracket from the access point.
4
Attach the mounting bracket to the T-bar clamp.
Universal mounting
bracket
T- bar
T-bar clamps
(attached
to T-bar)
Port connector
opening
(Viewed from above ceiling tiles, looking down.)
T-bar
Slide together
Port connector
opening
Nortel WLAN—Series 2332 Access Points Quick Installation
WLAN—Access Point 2330s 85
T-bar clamp halves
15.9-mm (5/8 inch) T-bar
Universal mounting bracket
T-bar
Slide together