Subsystem Cable Connections; Power Cables; Iscsi Host Ports; Com Port - Bosch DVA-12T Quick Installation Manual

RAID Subsystem DVA-12T | Quick Installation Guide
7

Subsystem Cable Connections

7.1

Power Cables

1.
Fig. 7.1 Power Supply Module
2.
3.
7.2

iSCSI Host Ports

1.
Fig. 7.2 Controller Module
2.
7.3

COM Port

The subsystem comes with one (1) COM port. The COM port is reserved for terminal emula-
tion management. This port can be used to access firmware's embedded configuration utility.
One (1) audio-jack to DB9 cable and a null modem are provided to facilitate the connection of
the COM port (see Figure 7.2).
Bosch Security Systems
Connect the two (2) provided power cables to the power sockets on the back of the sys-
tem (see Figure 7.1).
Make sure the power source is within the correct power range (100 to 240 VAC) prior to
powering on. Auto-ranging is supported by the power supply modules.
Plug the other end of power cords into the power source.
The subsystem comes with two (2) RJ-45 connectors at the rear of the controller module.
They can be connected to external network devices or iSCSI initiators, using standard
Cat6, RJ-45 Ethernet cables. The network cables should be purchased separately (see
Figure 7.2).
Attach one end of Ethernet cable to the subsystem and attach the other end to the net-
work devices or iSCSI initiators.
Subsystem Cable Connections | en
F.01U.027.801 | V2 | 2006.07
9