Connecting A Bosch Video Server - Bosch DVA-12T Quick Installation Manual

RAID Subsystem DVA-12T | Quick Installation Guide
12

Connecting a Bosch Video Server

This instruction explains how to connect a VIP X1600, VIP X1/2, Dinion, and a Gen4 Dome.
To connect a Bosch Video Server:
1.
2.
3.
4.
5.
6.
7.
NOTICE!
i
As configured in the subsystem, all LUNs must be visible. If not, please check your subsystem
configuration.
8.
9.
10. Proceed with the recording settings of your Bosch Video Server. For details, please refer
Bosch Security Systems
Open the Web browser.
Type the unit's IP address in the address bar, and then click the Go button. The Web
browser opens the LIVEPAGE.
Click the SETTINGS link in the upper section of the screen. The Web browser opens a
new page with the configuration menu.
In the navigation tree, click Recording Settings, and then click Storage medium. The
application opens the Storage medium dialog box.
In the Type: list, click iSCSI, and then click Set.
In the navigation tree, click iSCSI Settings. The application opens the iSCSI Settings dia-
log box.
In the Scan iSCSI IP address: box, type 192.168.0.100 (factory default), and then click
Scan. The connection to the IP address will be established and the iSCSI LUN map pane
shows the corresponding logical drives configured for the iSCSI storage device. The cur-
rent user is displayed for each drive.
In the iSCSI LUN map pane, double-click a free drive (LUN).
Click Set. If the storage medium is detected successfully, a message appears.
to the technical manual of the Bosch Video Server.
Connecting a Bosch Video Server | en
F.01U.027.801 | V2 | 2006.07
17