Replacement Of Lamp - Samsung CM1219 Service Manual

4-7 Replacement of Ventilation Motor
1. Remove the outer panel and back-cover.
2. Discharge the high voltage capacitor.
3. Remove all the lead wires from Magnetron and
High Voltage Capacitor.
4. Remove 2 screws securing the duct fan.
5. Remove 2 screws securing the Supporter-Fan-
Mount.
6. Lift the Ventilation Motor Ass'y slightly upward
and pull it out.
7. Remove lead wires and connectors.
8. Remove a screw securing the C-Film to the
Supporter-Fan-Mount.
9. Turn the fan motor ass'y over so that the
bracket side is up.
10. Remove 4 screws securing the Ventilation Motor.
4-8 Replacement of Tray
1. Open the door.
2. Remove the tray by inserting a thin metal tool into
the gap between the oven wall and the tray silicon
cover.
3. Insert the new tray by tilting it across the oven
cavity.
4. Firstly fix the front part (refers to the place where
the silicon cover is thinner than the other 3 edges)
and then place the backward part carefully and
firmly.
NOTE: Be careful when you handle the tray since it
is fragile.

4-9 Replacement of Lamp

NOTE: You don't need to remove the outer panel
or other parts in order to replace a lamp.
1. Remove a screw securing the lamp cover.
2. Remove the lamp by rotating it clockwise.
3. Replace with a new lamp by rotating it counter-
clockwise.
NOTE : If it is necessary to replace the lamp
holder, you can disconnect lead wires by
pushing down on the hole of lead wires
using a long pointed tool.
Samsung Electronics
Disassembly and Reassembly
Ventilation Motor
Duct-Fan
Tray
Lamp Cover
Outer Panel
C-Film
Supporter-Fan-Mount
Lamp Holder
17