Table of Contents
Advertisement
3. Disassembly and Reassembly
3-7 Replacement of Fan Motor
Parts
Fan Motor
3-8 Replacement of Tray
Parts
Explaination Photo
Assy
Stirrer
Tray
3-9 Replacement of Lamp
Parts
Explaination Photo
Assy
Lamp Cover
Stirrer
Outer Panel
Explaination Photo
Ventilation Motor
C-Film
Supporter-Fan-Mount
Duct-Fan
1.
Open the door.
2.
Remove the tray by inserting a thin metal tool into the gap
between the oven wall and the tray silicon cover.
3.
Insert the new tray by tilting it across the oven cavity.
4.
Firstly x the front part (refers to the place where the silicon
cover is thinner than the other 3 edges) and then place the
back ward part carefully and rmly.
NOTE
Lamp Holder
11
Explaination
1. Remove the outerpanel and back-cover.
2. Discharge the high voltage capacitor.
3. Remove all the lead wires from Magnetron
and High Voltage Capacitor.
4. Remove 2 screws securing the duct fan.
5. Remove 2 screws securing the Supporter-
Fan Mount.
6. Lift the Ventilation Motor Ass'y slightly left
upward and pull it out.
7. Remove lead wires and connectors.
8. Remove a screw securing the C-Film to
the Supporter-Fan-Mount.
9. Turn the fanmotor ass'y over soth at the
bracket side is up.
10. Remove 2 screws securing the Ventilation
Motor.
Explaination
: Be careful when you handle the tray since it is fragle.
Explaination
NOTE
: You donn't need to remove the outer
panel or other parts in order to replace a
lamp
1. Remove a screw securing the lamp cover.
2. Remove the lamp by rotating it clockwise.
3. Replace with a new lamp by rotating it
counter-clockwise
NOTE
: If it is necessary to replace the lamp
holder, you can disconnect lead wires by
pushing down on the hole of lead wires using
a long pointed tool.
Advertisement
Table of Contents
