Troubleshooting Guide - TEFAL OPTIGRILL Instructions For Use Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 39
TE_OPTIGRILL_DE_2100084302 20/02/14 15:09 Page52
Trouble shooting guide
Problem
Fixed white indicator light.
EN
The appliance stops during
the pre-heating or cooking cycle.
Indicator
flashing after
placing the food on the cooking plates.
Flashing white indicator light.
flashing
+ button
or button
flashing
The appliance no longer beeps.
I have put in my food and closed the
appliance but cooking has not started.
I have put in my food but the indicator
stays on PURPLE
Tip, especially for meat: the cooking results on the preset programmes may vary depending on origin, cut and
quality of the food being cooked, the programmes have been set and tested for good quality food.
52
Cause
• Starting a cooking cycle
without preheating.
• The appliance has been
kept open for too long
while preheating or
cooking.
• The appliance has been
idle too long after the
end of warm up or keep
warm.
• Not sensing the food.
Meat thickness too thin.
• Appliance failure.
• Appliance stored or
used in a room that
is too cold.
• Your food has a depth
thicker than 4 cm.
• Your food is under
4 mm thick.
• You have not waited
for the appliance to
pre-heat.
• You have not
completely opened the
.
grill when putting on
the food.
• Not sensing the food.
Meat thickness too thin.
Minimum thickness =
4mm
Solution
• 2 possible options:
- allow to cook, but you must monitor
the cooking (white LED = manual
mode)
- stop the appliance, remove the food,
close the appliance properly,
reprogram the appliance and wait
until end of preheating.
• Disconnect the appliance from the
mains leave for 2-3 mins, restart the
process. The next time you use the
appliance, make sure you open and
close it briefly for best cooking results.
If the problem continues, contact your
local Tefal Customer Service.
• You must confirm the start of the
cooking by pressing the button
• Disconnect and reconnect your
appliance and immediately restart
a preheat cycle.
If the problem persists, contact
your Customer Service.
• Food must not be thicker than 4cm.
• You must confirm the start of the
cooking by pressing the button OK.
• Wait for the audible beep and the
cooking level indicator to flash purple
before adding food.
• Completely open the grill then close it.
• Confirm the start of the cooking
by pressing the button
.
.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents