NordicTrack ViewPoint NTL11806.0 User Manual page 11

11. See drawing 11a. Remove the indicated 3/4"
Screw (7) from the right Handrail (70).
See drawing 11b. Slide the Right Upright Sleeve
(9) up to the console assembly. Attach the Right
Upright Sleeve with two 1" Tek Screws (82) and
the 3/4" Screw (7) as shown.
Attach the Left Upright Sleeve (not shown) in the
same way.
12 With the help of a second person, carefully
lower the Uprights (85) to the position shown.
Attach the Right Base Cover (86) with three 3/4"
Screws (7) and two Base Cover Screws (63).
Start all five Base Cover Screws and then
tighten them. Be careful not to overtighten
the Base Cover Screws. Attach the Left Base
Cover (88) in the same way.
With the help of a second person, carefully raise
the Uprights (85) to the vertical position.
13. Note the location of the 75 ohm antenna terminal
on the treadmill. For the television to operate
properly, an antenna, a CATV cable, or a VCR
must be connected to the 75 ohm antenna termi-
nal (see page 13).
14. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key
in a secure place. The hex key is used to adjust the walking belt (see page 30). To protect the floor or car-
pet from damage, place a mat under the treadmill.
11a
70
7
12
85
86
13
11
11b
Console
Assembly
7
9
88
7
63
75 Ohm
Antenna
Terminal
82
7
63