NordicTrack NTL16950 User Manual page 9

If you purchase the optional chest pulse sensor (see page 26), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1. Make sure that the key is removed from the console
and the power cord is unplugged. Remove the indi-
cated 3/4" Screw (7) and the Access Door (95) from the
left side of the Console Back (96).
2. Connect the wire on the receiver (A) to the indicated wire
extending from the Console Back (96). Hold the re-
ceiver so the small cylinder is oriented as shown and
is facing the Console Back. Attach the receiver to the
plastic posts on the Access Door (95) with the two in-
cluded small screws.
3. Make sure that no wires are pinched. Reattach the
Access Door (95) with the 3/4" Screw (7). Discard the
other wires included with the receiver.
96
95
7
9
Small
Screws
Wire
A
Small
Cylinder