Mobile Home Installation; Gas Installation - Napoleon GD33NR Installation And Operating Instructions Manual

20
Remove the screws securing the restrictor plate and ro-
tate the plate 180°. Secure using the same two screws
through the existing holes.
RESTRICTING VERTICAL VENTS (BGD33 ONLY)
Warning:
This restrictor (located
in the lower valve
compartment) must not
be installed on any vent
configuration that has a
horizontal termination
or vertical vent with
vertical termination less than 10'.
Vertical installations over 10' may display a very active
flame. If this appearance is not desirable, install the
restrictor plate. This reduces the velocity of the exhaust
gases, slowing down the flame pattern and creating a
more traditional flame appearance.

MOBILE HOME INSTALLATION

This appliance may be installed as an OEM (Original
Equipment Manufacturer) installation in a manufactured
home or mobile home and must be installed in accordance
with the manufacturer's instructions and the Manufactured
Home Construction and Safety Standard, Title 24 CFR,
Part 3280, in the United States or the Mobile Home Standard,
CAN/CSA Z240 MH Series, in Canada.
This Mobile/Manufactured Home Listed appliance comes
factory equipped with a means to secure the unit.
The fireplace is equipped with two 1/4" diameter holes
located in the front left and right corners of the base. For
mobile home installations, the fireplace must be fastened
in place. Use #10 hex head screws, inserted through the
holes in the base to secure.
Always turn off the pilot and the fuel supply at the source,
prior to moving the mobile home.
After moving the mobile home and prior to lighting the
fireplace, ensure that the logs are positioned correctly.
This appliance may be installed in an aftermarket
permanently located, manufactured (mobile) home, where
not prohibited by local codes.
This appliance is only to be used with the type of gas
indicated on the rating plate. This appliance is not
convertible for use with other gases, unless a certified kit
is used.
Conversion Kits
The mobile home appliance is field convertible between
Natural Gas (NG) and Propane (LP). To convert from one
gas to another consult your Napoleon
W415-0341 / K / 10.05.07
FIGURES 35a-b
Proceed once the vent installation is complete.
1. Route a
per tubing or equivalent to the fireplace.
2. For ease of accessibility, an optional remote wall
switch or millivolt thermostat may be installed in a
convenient location. Route 2-strand (solid core) millivolt
wire through the electrical hole located at the bottom left
side of the unit. The recommended maximum lead length
depends on wire size:
Attach the two leads to terminals 1 and 3 located on the
gas valve.
FIGURE 37
FIGURE 36
Do not connect either the wall switch, thermostat or
gas valve to electricity (110 volts).
3. Install rigid black pipe, ½" type-L copper tubing or, if
local codes permit, a
to the gas line and the fireplace gas valve. Seal and tighten
securely. An adapter fitting is required between the gas
valve and the copper tubing or flex connector.
DO NOT KINK FLEXIBLE CONNECTOR.
4. Check for gas leaks by brushing on a soap and water
solution.
Purge all gas lines with the glass door of the fireplace
removed. Assure that a continuous gas flow is at the
burner before re-installing the door.
®
dealer/distributor.

GAS INSTALLATION

3 / " N.P.T. black iron gas line, ½" type-L cop-
8
TABLE 3
WIRE SIZE MAX. LENGTH
14 gauge 100 feet
16 gauge
18 gauge
3
/ " flex connector and shutoff valve
8
FIGURE 38
Do not use open flame.
60 feet
40 feet