Sony SAVA-59 Operating Instructions Manual page 2

Hide thumbs Also See for SAVA-59:
Table of Contents

Advertisement

WARNING
To prevent fire or shock
hazard, do not expose
the unit to rain or
moisture.
This symbol is intended to alert the user
to the presence of uninsulated
"dangerous voltage" within the
product's enclosure that may be of
sufficient magnitude to constitute a risk
of electric shock to persons.
This symbol is intended to alert the user
to the presence of important operating
and maintenance (servicing)
instructions in the literature
accompanying the appliance.
INFORMATION
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and
can radiate radio frequency energy and,
if not installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications.
However, there is no guarantee that
interference will not occur in a
particular installation. If this equipment
does cause harmful interference to
radio or television reception, which can
be determined by turning the
equipment off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
- Reorient or relocate the receiving
antenna.
2
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
CAUTION
You are cautioned that any changes or
modifications not expressly approved in
this manual could void your authority
to operate this equipment.
Owner's record
The model and serial numbers are located
on the rear of the unit. Record the serial
number in the space provided below.
Refer to them whenever you call upon
your Sony dealer regarding this product.
Model No. SAVA-59
Serial No.
For the customers in Canada
CAUTION
TO PREVENT ELECTRIC SHOCK, DO
NOT USE THIS POLARIZED AC PLUG
WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET
UNLESS THE BLADES CAN BE FULLY
INSERTED TO PREVENT BLADE
EXPOSURE.
Precautions
On safety
• Should any solid object or liquid fall
into the cabinet, unplug the speaker
system and have it checked by
qualified personnel before operating
it any further.
On power sources
• AC power cord must be changed only
at the qualified service shop.
• Before operating the speakers, check
that the operating voltage is identical
with your local power supply. The
operating voltage is indicated on the
nameplate on the rear of the speakers.
• The speakers are not disconnected
from the AC power source (mains) as
long as they are connected to the wall
outlet, even if the speakers
themselves have been turned off.
• If you are not going to use the
speakers for a long time, be sure to
disconnect the speakers from the wall
outlet. To disconnect the AC power
cord, grasp the plug itself; never pull
the cord.
• One blade of the plug is wider than
the other for the purpose of safety
and will fit into the wall outlet only
one way. If you are unable to insert
the plug fully into the outlet, contact
your dealer.
On placement
• Do not install the appliance in a
confined space, such as a bookcase or
built-in cabinet.
• Do not place the speakers near heat
sources, or in a place subject to direct
sunlight, excessive dust or
mechanical shock.
• Good ventilation is essential to
.
prevent internal heat buildup. Place
the speakers in a location with
adequate air circulation, and in a way
that does not block the rear
ventilation holes.
On cleaning
• Clean the cabinet, panel and controls
with a soft cloth slightly moistened
with a mild detergent solution. Do
not use any type of abrasive pad,
scouring powder or solvent such as
alcohol or benzine.
If you have any question or problem
concerning your speaker system, please
consult your nearest Sony dealer.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents