Reversing The Door Hang; Replacing The Decorative Door Panel - Dometic RH 423 LDA Operating Instructions Manual

GB
mm
Attention!
By mounting the LED cable take care of the correct
distances otherwise the too short cable will not allow
you to open the door fully.
3. Put the LED-holder (B) into the hole from outside.
4. Mount to insulation (C) with the LED cable and then,
snap it to the LED-holder and fit the cable (Fig. 12).
5. Connect the miniBar to the mains. After opening the
door the red LED must be lighten.
6. To reset the LED signal please act according to the
steps described at the freestanding version.

8. Reversing the door hang

Reversing is suggested to perform in the following
way, in order to avoid breaking of the hinge bolt:
5
7
6
Disconnect the mains
Lay the appliance down carefully on its back
Take down the two foot-extension (1) pieces by
removing the two screws (2)
Remove the four screws (4) and take out the two
fixing feet (3)
8
mm
Door front
Door front
Place of LED
Figure 11.
Figure 12.
(Fig. 13.)
9
8
1 1
3
4
2 2
Figure 13.
Remove the four screws (7) the upper hing (5)
and the cover cap (6)
Remove the door (8), together with the upper
hinge (5), from the housing
Insert the upper hinge (attached the miniBar)
and the covering plate in the slot on the opposite
side and secure with four screws (7).
Insert the door on the upper hinge and place it.
Mount the fixing feet (3) with hinge bolts (9)
placed into the opposite side of the feet
Mount the two foot-extension pieces (1)
Check that the door closes easily and is sealed
properly.
9. Replacing the decorative
door panel
(Fig. 13., 14.)
(only free-standing model)
Removing and mounting of the door is similar to
that of described in the previous, 9 chapter. (Only
the foot on the hinge-side has to be removed!)
Remove screws (4) and pull off the frame edge (5).
Slide the decorative panel (6) out of the door frame
and insert the new panel (7), so that the upper edge
of the panel runs exactly parallel to the upper edge of
the frame. A new panel can be inserted more easily
into the upper edge of the frame when the two
corners are cut off by approx. 5 x 5 mm (8). Put the
frame edge (5) back in place and secure with screws.
Place the door on the lower hinge (9), slot the
upper hinge into the opening, press together with
the door against the housing and secure with the
two screws (11).
Figure 14.
10. Assembly of door handle
optional
Figure 15.
(Fig. 15)