Waste Disposal; Motor Oil Disposal - Exmark LAZER Z CT Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983

6. WASTE DISPOSAL

6.1 MOTOR OIL DISPOSAL

Engine oil and hydraulic oil are both pollutants to the environment. Dispose of used oil at
a certified recycling center or according to your state and local regulations.
f) Start engine. Brake must be engaged and motion control levers out to
start engine. Operator does not have to be in the seat because of the
jumper wire being used. Run engine at full throttle and release brake.
g) The reverse indicator spring must be correct before the following
adjustments can be made. See Section 5.2.10.
h) Bring the RH motion control lever into the neutral position. Adjust RH pump
control rod length by rotating the double nuts on the rod in the appropriate
direction until the wheels slightly creep in reverse. (See Figure 11). Move
the motion control lever to the reverse position and while applying slight
pressure to the lever, allow the reverse indicator spring to bring the levers
back to neutral. The wheel must stop turning or slightly creep in reverse.
NOTE: The motion control lever needs to be in neutral while making
any necessary adjustments.
The left rod assembly controls the left wheel and the right rod assembly
controls the right wheel.
i) Bring the LH motion control lever into the neutral position. Adjust the LH
pump control rod length by rotating the tracking adjustment knob in the
appropriate direction until the wheels slightly creep in reverse. Move the
motion control lever to the reverse position and while applying slight
pressure to the lever allow the reverse indicator spring to bring the levers
back to neutral. The wheel must stop turning or slightly creep in reverse.
See Figure 12.
LH MOTION CONTROL ADJUSTMENT
j) Shut off unit. Remove jumper wire from wire harness connector and plug
connector into seat switch.
www.mymowerparts.com
FIGURE 12
- 33 -