ASSEMBLY
Assembly requires two people. Place all parts of the stepper in a cleared area and remove the packing mate-
rials. Do not dispose of the packing materials until assembly is completed. In addition to the included allen
wrenches, assembly requires an adjustable wrench
As you assemble the stepper, use the drawings below to identify the small parts used in assembly. The number
in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 18. The
second number refers to the quantity used in assembly. Note: Some small parts may have been pre-assem-
bled for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.
M8 Nylon
Locknut (28)–4
Console
Screw (57)–4
M10 x 25mm Button
Screw (29)–4
M8 x 35mm
Button Bolt (24)–4
1. While another person lifts and holds the indicated end
of the Frame (1), attach the Front Stabilizer (95) to the
Frame with two M10 x 75mm Button Screws (92).
Make sure that the Front Stabilizer is turned so the
Wheels (67) are not touching the floor.
M10 Nylon
Locknut (27)–4
4
and a rubber mallet
M8 Split
Washer (54)–4
M10 x 75mm Button
Screw (92)–2
M10 x 82mm Button
Bolt (26)–4
M10 x 91mm Button
Screw (63)–2
1
67
92
67
95
.
M10 Split
Washer (30)–6
1