Connection Overview For Additional Wiring Harnesses - BMW 65 90 0 151 635 Installation Instructions Manual

4. Connection overview for additional wiring harnesses

18
A3
A2
A1
Item Description
A Power supply wiring harness
A1
Black 8-pin plug casing
A2
Black 8-pin socket casing
A3
Connection plug with Mute
twin-lead terminal
A4 5 A suspended fuse
A5 Black 6-pin socket casing
A6 Black 2-pin socket casing
mute/terminal 30
A7 Black 3-pin socket casing
Navi NF
A8 Open cable end, reversing light
A9 Open cable end terminal 58
(Registration plate light)
A10
A11 Cable eyelet 6 mm in diameter
Black 8-pin socket casing
A12
Brown 8-pin socket casing
18
Black 1-pin socket casing
Retrofit/Installation kit No. 65 90 0 151 635 (others see cover sheet)
Installation instructions No. 01 29 0 028 872
A4
A
A5 A6
Cable colour
-
-
-
black
red/green
-
red/green
black
black
blue/yellow
blue/green
blue/yellow
grey/yellow
brown
-
-
-
A10
A7 A8 A9
Connection site in the car
-
To black 8-pin socket casing X322B behind the heating/air
conditioning control
To black 8-pin plug casing X322S behind the heating/air
conditioning control
To black 17-pin socket casing X18124 PIN 4
To audio wiring harness below the monitor console
To black 6-pin plug casing on the control in the centre console
To black 2-pin plug casing on the switch module
To black 3-pin plug casing on the switch module
To light cable loom near the rear right wheel arch using an
insulation-piercing connector (check that the required signal exists)
With insulation-piercing connector to the light cable loom,
grey/brown cable, near the rear left wheel arch (check whether the
required signal is available)
To earth post X13016 in the boot on the left
To Mark III navigation computer in the boot (chamber A
To Mark III navigation computer in the boot (chamber B)
To released socket contact from PIN 4 of the radio connection
plug X18126
Issue date: 06.2002
A11
A12
F 46 1168 B
EN/5