BMW 65 90 0 151 635 Installation Instructions Manual page 14

9. To install and connect the additional wiring harnesses
X18126
A4
A
A8
30
Retrofit/Installation kit No. 65 90 0 151 635 (others see cover sheet)
Installation instructions No. 01 29 0 028 872
7
A5
B1
F 46 1175 B
A7
A6
F 46 1176 B
A9
6
F 46 1177 B
Secure branch A4, suspended 5 A fuse,
red/green cable, on the power supply wiring
harness A, to the audio wiring harness (30) using
a cable tie (7).
Lay branch A5, black 6-pin socket casing, and
branch B1, black 16-pin socket casing, straight,
on the monitor wiring harness, on the carpet.This
will later be connected to the monitor console.
Lay branches A6 and A7 on the power supply
wiring harness A to the installation site of the
switch module near the A pillar at the bottom left.
The remainder of the connection diagram for
branches A6 and A7 is described in the
installation instructions headed "Telephone
switch module and Mark IIi navigation system
installation instructions" .
The figure shows the rear right wheel arch from
the inside.
Carefully cut open the light cable loom (30) and
use a measuring instrument to check that the
cables you require can supply the required
signal.
Cable colour
blue/yellow
grey/brown
Connect branch A8, open cable end, blue/yellow
cable, with double insulation-piercing connector
(6) to the blue/yellow cable you checked earlier
on the light cable loom (30).
Connect branch A9, open cable end, grey/yellow
cable, with double insulation-piercing connector
(6) to the grey/brown cable you checked earlier
on the light cable loom (30).
Issue date: 06.2002
Signal
Terminal RS reversing light
Terminal 58 (Registration
plate light)
EN/12