Thermador PRD364NLGU Dimension Manual page 5

PRD364NLGU
36-INCH DUAL-FUEL PRO GRAND
WITH GRILL
PROFESSIONAL SERIES, COMMERCIAL-DEPTH, PORCELAIN COOKTOP SURFACE
36-INCH RANGE DIMENSIONS AND CLEARANCE REQUIREMENTS WITH "FLUSH ISLAND TRIM"
36" (914 mm) min.
to combustible
materials
35 / " (911 mm) Min.
7
8
36¾" (933 mm) Max.
As defined in the "National Fuel Gas Code" (ANSI Z223.1, Current Edition).
Clearances from non-combustible materials are not part of the ANSI Z21.1
scope and are not certified by CSA. Clearances of less than 12" (305 mm)
must be approved by the local codes and/or by the local authority having jurisdiction.
These warranties give you specific legal rights and you may have other rights that vary from state to state. Full warranty and limited warranty from date of installation. For complete warranty
details, refer to your Use & Care manual, or ask your dealer.
Specifications are for planning purposes only. Refer to installation instructions and consult your countertop supplier prior to making counter opening. Consult with a heating and ventilation
engineer for your specific ventilation requirements. For the most detailed information, refer to installation instructions accompanying product or write to Thermador indicating the model
number. Specifications are correct at time of printing. Thermador reserves the right to change product specifications or design without notice. Some models are certified for use in Canada.
Thermador is not responsible for products that are transported from the U.S. for use in Canada.
1 800 735 4328 | USA THERMADOR.COM | CANADA THERMADOR.CA | ©2015 BSH HOME APPLIANCES CORPORATION. ALL RIGHTS RESERVED.
Installation Clearances with Flush Island Trim
12" (305 mm) min. to 12" (305 mm) min. to
combustible surface combustible surface
with Flush Island Trim with Flush Island Trim
31¼" (794 mm)
/
29 1 " (740 mm)
8
25 / " (638 mm)
1
8
max. recess depth
26 / " (683 mm)
7
8
48¾" (1238 mm)
RANGE
®
If an inner wall
is used under the
cantilever counter
top, there should be a
/
1 " (3 mm) gap from
8
the rear of the range
to the inner wall.
Page 5 of 5
Combustible
Materials
Shaded area behind Shaded area behind
range indicates range indicates
minimum clearance minimum clearance
to combustible surfaces, to combustible surfaces,
combustible materials combustible materials
cannot be located within cannot be located within
this area. this area.
For Flush Island Trim For Flush Island Trim
installations, counter installations, counter
surface should have surface should have
a cantilever edge a cantilever edge
meeting the back meeting the back
section of the Flush section of the Flush
Island Trim accessory. Island Trim accessory.
Combustible
Back Wall
11 / 15