Splash Guard; Helpful Hints - Sunbeam FPSBSM3481 series User Manual

h T
OW O
T a
O TTaCh
1. Rotate Control Knob to OFF position to turn unit off.
2. Unplug Stand Mixer.
3. After bowl and attachment are in place, lock mixer
head into the downward position.
4. From the front of the mixer, slide the Splash Guard over
the bowl until centered and chute is to the right. The inner
rim of the Splash Guard should fit against the inside edge
of the bowl.
NOTE: Splash Guard should fit loosely on bowl for easy assembly.
Be sure to hold lid in place while pouring.
T u s
O se plash
1. For best results, rotate Splash Guard so the mixer head fits into
the opening of the Splash Guard. The pouring chute will be just
to the right of the attachment hub as you face the mixer.
2. While securing Splash Guard with one hand, pour the
ingredients into the bowl through the pouring chute.
T r
O emOve
1. Rotate Control Knob to OFF position to turn unit off.
2. Unplug Stand Mixer.
3. Lift the front of the Splash Guard clear of the bowl rim
and pull forward.
NOTE: Remove chute and Splash Guard before lifting the tilt head.
h
elpful
• When mixing liquids, especially hot liquid, make small quantities at a time to reduce spillage.
• Ingredients should be added to the mixing bowl in the order they are specified in the recipe.
• Use the mixing speed that is recommended in the recipe. Use the speed control dial of the
mixer to help you find the correct speed to use.
• Use mixing times as specified in recipes. BE CAREFUL NOT TO OVERMIX. Overmixing can
cause the mixture to become very tough.
• Should an object, such as a spatula, fall into the bowl while the mixer is operating, turn the
mixer OFF immediately, then remove the object.
• For easier clean-up remove attachments and rinse immediately with warm water.
• Mixer is designed to operate in orbital pattern; periodic scraping of bowl sides may be
required during mixing. Turn OFF before scraping.
8
FPSBSM3481-033_14EFM1.indd 9-10
u T s
se he plash
s g
plash uard
(figure A):
g :
uard
s g
plash uard
(figure B):
h
InTs
g
uard
Figure A
Figure B