Table of Contents
Advertisement
fig. 7
Using Your Carpet Glider
fig. 8
THE CARPET GLIDER
1
The Carpet Glider can be used with the Rectangular
Head to lightly steam your carpet and area rugs.
Just place the mop head with cleaning pocket
attached into the glider. (fig. 8)
7
FREEPHONE 0800 862 0453
6
Use the shaggy side of the cleaning pockets to lift
up and lock away all the dirt and debris and the
scrubbing side to break up the tough stains. (fig. 7)
7
When the water tank is empty, the Steam Mop will
stop producing steam. You can refill the water tank
at any time as long as the mop is unplugged from
the outlet. Follow the instructions from page 8. This
applies to switching the mop head or cleaning pocket
as well.
NOTE: Please wait 2-3 minutes for the Steam Mop
to cool off before switching the mop head or the
cleaning pocket. Never leave the Steam Mop with a
damp/wet cleaning pocket on any floor.
8
When you are done, press the power button to turn
the steam mop off.
The Steam Mop will not clean your
carpeting or area rugs. However, it is
great for grooming and freshening.
fig. 9
2
Move the Steam Mop back and forth across a
section of the carpet. (fig. 9)
Using Your Handheld Steamer
Your Shark
Multi-Function Steam Pocket
Mop
®
®
Lite is designed to clean surfaces that will withstand high
heat and moisture. Do not use on unsealed wood surfaces
(especially wooden antique furniture), unglazed ceramic
tile, painted surfaces or surfaces that have been treated
with wax, oils, varnishes, or shellac. The sheen may be
removed by the heat, steam, and friction of the cleaning
tools. Lacquer and polyurethane coatings provide a hard
durable protective finish that withstands moisture, but it
is always recommended to test an isolated area of the
surface to be cleaned before proceeding.
We also recommend you check the use and care
instructions from the surface manufacturer.
When cleaning finished wood surfaces, use broad,
continuous cleaning strokes. To prevent surface damage,
avoid focusing steam or allowing the cleaning tools to sit
in one spot for any amount of time.
fig. 10
1
To remove the Handheld Steamer, press and hold
down the Handle Release Button while pulling out
the handle. (fig. 10)
2
To remove the mop head, press the mop head
release button and pull the mop head off. (fig. 10)
www.sharkclean.eu
8
Advertisement
Table of Contents
