Using Your Carpet Glider - Shark S3901 Series Owner's Manual

Using Your Steam Mop - cont'd
fig. 12

Using Your Carpet Glider

THE CARPET GLIDER
1
The Carpet Glider can be used with the All-Purpose
Head to lightly steam your carpet and area rugs. Just
place the mop head with cleaning pocket attached
into the glider. The recommended steam setting is
SCRUB when using the Carpet Glider. (fig. 13)
11 1-800-798-7398
5
6
fig. 13
2
When one side of the cleaning pocket (P119W or
P118W) gets dirty, just flip the mop and you can
quickly start using the other side. Use the shaggy
side of the cleaning pockets (P129W or P140W) to
lift up and lock away all the dirt and debris and the
scrubbing side to break up the tough stains. (fig. 12)
When the water tank is empty, the Steam Mop will
stop producing steam. You can refill the water tank
at any time as long as the mop is unplugged from
the outlet. Follow the instructions from page 7. This
applies to switching the mop heads or cleaning
pockets as well.
NOTE: Please wait 2-3 minutes for the Steam Mop
to cool off before switching the mop head or the
cleaning pocket. Never leave the Steam Mop with a
damp/wet cleaning pocket on any floor.
The Steam Mop will not clean your carpeting or
area rugs. However, it is great for grooming and
freshening.
Move the Steam Mop back and forth across a
section of the carpet. (fig. 14)
fig. 14