LG DLEX4270 Series Owner's Manual page 49

TROUBLESHOOTING
49
Before calling for service (cont.)
Problem
Steam does not
generate but
no error code is
shown
Possible Causes " Solutions
• Water level error. Unplug dryer and call for service.
Garments still • Too many or too different types
wrinkled after of garments in dryer.
STEAM FRESH
TM
There are no • The function of this cycle is to
creases left on remove wrinkles from fabric.
garment after
STEAM FRESWM
Garments have • This is normal.
static after
REDUCE STATIC
Garments are • Correct drying options not
too clamp or too selected.
dry after REDUCE
STATIC
Garments are not • Number of garments or load
uniformly clamp size not properly selected at
after EASY IRON the beginning of the cycle.
Water drips from . This is normal.
door during
Steam Cycle
Steam is not .This is normal.
visible during
Steam Cycle
Drum does not • This is normal.
turn during
Steam Cycle
Cannot see .This is normal.
steam vapor at
the beginning of
cycle
The display • MORETIME button pressed.
sh°ws 81 9
Small loads of 1 to 5 items work best.
Load fewer garments. Load similar-type garments.
Use an iron to make creases.
Depends on individual moisture level in skin.
Select load weight manually before starting REDUCE
STATIC option.
Select the correct number or garments or load size
before starting the cycle.
Condensation will normally form on the inside of the
dryer door during steam operation. Some condensation
may drip out the bottom of the door.
Steam vapor is difficult to see when the door is closed.
However, condensation will normally form on the
inside of the dryer door if the steam system is operating
normally.
. The drum is turned off so that the steam vapor remains
in the drum. The drum will normally turn for about 2
seconds once a minute.
Steam is released at different stages of the cycle for each
option.
• This display indicates that the steam option has been set
for a" bt 9" item such as a comforter.
Press the LESSTIME button to reduce the indicated load
size.