Glass Surfaces; Painted Surfaces - GE JHP70GN Use And Care Manual

Microwave cooking center
Table of Contents

Advertisement

The duct allows moisture and vapors to be released
from the oven. The oven is vented through a duct
centered under the right rear surface unit.
Removable Storage Drawer
The storage drawer is a good place to store cookware
and bakeware. Do not store plastics and flammable
material in the drawer.
Do not overload the storage drawer. If the drawer is
too heavy, it may slip off the track when opened. To
open the drawer, grasp the center of the handle and
pull straight out.
The storage drawer may be removed for cleaning
under the range.
To remove: Pull the drawer straight out and lift over
the guide stops.
To replace: Lift over the guide stops and slide the
drawer into place.
-
use of the oven. Clean with mild soap and water or
vinegar and water, rinse with clean water and polish
dry with a soft cloth.
Do not use abrasive cleansers, strong liquid
cleansers, plastic scouring pads or oven cleansers
on the control panel—they will damage the finish.
A 50/50 solution of vinegar and hot water solution
works well.
The control knobs may be removed for easier
cleaning. The knob stem has a groove in each side.
The groove on one side has a spring clip. The other
groove is clear (see illustration). Check the inside of
the knob and find the molded rib. Replace the knob by
fitting the molded rib inside the knob into the clear
groove on the stem. Wash the knobs in soap and water
or a vinegar and hot water solution but do not soak.

Painted Surfaces

Painted surfaces include the outside
oven door, sides, control panel and
drawer front. Clean these with soap
oven cleaners, cleansing powders,
steel wool or harsh abrasives on
any painted surface.
To clean the duct: Remove the surface unit and drip
pan. Make sure the duct opening is unobstructed.
Never cover the hole.
To clean both the inside and the outside:
Wipe with soap and water. Rinse well.
Do not use cleansing powders or harsh abrasives
which may scratch the surface.
To clean the outside glass finish, use a glass cleaner.
Do not allow the water or cleaner to run down inside
openings in the glass while cleaning.
Metal parts can be cleaned with soap and water.
Do not use steel wool, abrasives, ammonia, acids or
commercial oven cleaners. Dry with a soft cloth.
Clear Groove
in Stem
Metal Parts
Do not use steel wool, abrasives,
ammonia or commercial oven
cleaners. To safely clean surfaces;
wash, rinse and then dry with a
soft cloth.

Glass Surfaces

To clean the outside glass finish,
use a glass cleaner. Rinse and
polish with a dry cloth. Do not
allow the water or cleaner to run
down inside openings in the top
of the oven door while cleaning.
(continued ne.~t page)
47

Advertisement

Table of Contents
loading

Table of Contents