Pride Mobility JAZZY 1170 XL Owner's Manual page 25

I V . C O M F O R T
NOTE: Be sure you are on a flat level surface before activating the power elevating seat.
Power Elevating Seat Operation
You can control the power seat through either the toggle switch located on the armrest or your through
controller. For information on how to raise and lower your power seat through your controller, see VII.
“Operation.”
To operate the power elevating seat:
1. Push the toggle switch forward to raise the seat. See figure 22. When you release the toggle, the seat
will stop. Once the seat reaches its highest extension, the lift action stops; you should continue to hear
and/or feel the lift motor running. This is because there is a clutch mechanism that allows the motor to
continue running after the lift has reached its limit. This clutch works at both the top and bottom
extensions of the lift.
WARNING! Do not allow the motor to run more than a few seconds after the mechanism reaches
the top or bottom limit.
2. Pull the toggle switch rearward to return the seat to its lowest position. When returning to the lowest
position, always be sure that the mechanism has reached its lowest limit.
To use the swivel feature, locate the swivel lever under the seat. It is located on the opposite side of the
controller. Push down on the lever to rotate the seat in 90° increments.
Jazzy 1170XL
Figure 22. Toggle Switch
www.pridemobility.com
A D J U S T M E N T S
25