Hotpoint HS2321L Service Information page 13

SMARTCARD PROGRAMMING PROCEDURE - FLOWCHART
DISCONNECT THE SMARTCARD READER FROM THE
APPLIANCE AND THE SMARTCARD FROM THE
SMARTCARD READER AND ACTION BELOW:
RED LED was flashing SLOWLY, and a
If the
smartcard was inserted, check for the following:
Invalid/erased smartcard (previously used)
Discard the invalid smartcard,
Incorrectly inserted smartcard,
(check orientation of the smartcard chip)
Poor connection between the smartcard and
smartcard reader.
RED LED was flashing RAPIDLY, check for the
If the
following:
Ensure a smartcard was inserted into the
smartcard reader,
Ensure the smartcard was fully inserted?
RED
IF THE LED IS FLASHING
COMMUNICATION PROBLEM
SMARTCARD INVALID/ERASED
DISCONNECT (unplug) THE APPLIANCE FROM THE
ELECTRICAL SUPPLY (grid)
DOWNLOAD OK
THE SMARTCARD CONTENT WILL BE
AUTOMATICALLY ERASED
START
DISCONNECT (unplug) THE APPLIANCE FROM THE ELECTRICAL SUPPLY (grid)
INSERT A VALID SMARTCARD, RELATING TO THE MODEL & MAIN POWER
MODULE (board) TO BE PROGRAMMED, INTO THE SMARTCARD READER
INSERT THE SMARTCARD READER INTO EITHER THE SERIAL PORT OF THE
POWER MODULE (BOARD) OR INTO THE LOW END ADAPTOR (Version 2007)
WHERE APPLICABLE
RE CONNECT THE APPLIANCE TO THE ELECTRICAL SUPPLY (GRID). A STATIC
RED
LED WILL LIGHT UP TO SIGNAL THAT THE SMARTCARD READER IS
SUPPLIED
IS THE
NO
GREEN
LED
FLASHING?
YES
CONNECTION IS VERIFIED (OK) DOWNLOAD NOW IN PROGRESS
IS THE
YES
GREEN
LED
STATIC?
THE POWER MODULE IS NOW PROGRAMMED.
DISCONNECT (unplug) THE APPLIANCE FROM THE ELECTRICAL SUPPLY (grid)
REMOVE THE SMARTCARD READER
(DISCONNECT THE LOW END ADAPTOR WHERE USED)
RESOLVE THE PROBLEM:
FURTHER DIAGNOSTICS MAY BE REQUIRED
ON THE APPLIANCE
DISCONNECT THE SMARTCARD READER
FROM THE APPLIANCE AND THE
SMARTCARD FROM THE SMARTCARD
READER
IF THE DOWNLOAD FAILED THE SMARTCARD
WOULD NOT HAVE BEEN ERASED
RED
NO
IF THE LED IS STATIC (fixed):
DOWNLOAD HAS FAILED (KO)