One for All 6-Device Universal Remote with Learning User Manual page 18

SOLUTION: Try all listed codes for the
device brands being set
up. Make sure they can be
operated with an infrared
remote control.
PROBLEM: TV/VCR Combo does not
respond properly.
Use the VCR codes for your
SOLUTION:
brand. Some combo units
may require both a TV code
and a VCR code for full
operation.
PROBLEM: Changing channels does
not work properly.
SOLUTION: If the original remote
control required pressing
ENTER to change channels,
then press ENTER on the
remote control after
entering the channel
number.
PROBLEM: During learning, LED
emits a long blink after
pressing and holding key
to be learned.
SOLUTION: Memory is full or a bad
capture has occurred.
Avoid high-ambient light
sources, such as direct
daylight and fluorescent
bulbs. Try readjusting
positions of remote
controls before performing
the procedure again.
PROBLEM: Tried Searching For Your
Code method and still
could not find a working
code.
SOLUTION: Clear the device key as
follows: Press and hold SET
until the LED (red light)
blinks twice, then
release.Next enter 9 9 2.
Then press the device key
to be cleared twice.Now
repeat the Searching for
Your Code method on page
8.
CH+ and CH- do not work
PROBLEM:
for your RCA TV.
SOLUTION: Due to RCA design (1983-
1987), only the original
remote control will operate
these functions.
PROBLEM: No remote control of
volume.
SOLUTION: See "Changing Volume
Lock" on page 14 to lock/
unlock volume.
PROBLEM: If the above does not work.
SOLUTION: Please contact us in any of
the following ways:
• Please visit:
• If the above website is
• Customer Support:
O ' M
WNER S ANUAL
www.oneforall.com
not able to provide you
with the information
you need, please email
us at
ofasupport@ueic.com
and refer to
"Troubleshooting"
(330) 405-8516
Mon- Fri from 9AM to
5PM ET
Troubleshooting 17