MAINTENANCE AND LUBRICATION
Battery
Battery Installation
If electrolyte spills, immediately wash it off with a solution of one
tablespoon baking soda and one cup water to prevent damage to
the UTV.
To avoid the possibility of explosion, always connect battery
cables in the order specified. Red (positive) cable first; black
(negative) cable last.
1. Set the battery in its holder.
2. Install the battery vent tube. It must be free from obstructions and
securely installed. If not, battery gases could accumulate and cause
an explosion. The tube should be routed away from the frame and
body to prevent corrosion. Avoid skin contact with electrolyte as
severe burns could result.
3. First connect and tighten the red (positive) cable.
4. Second connect and tighten the black (negative) cable.
5. Verify that cables are properly routed.
NOTE: When your UTV is placed in storage for three months or
more, the battery should be removed, charged to proper level, and
stored in a cool dry place. Before reusing, take the battery to your
dealer for testing and recharging.
CAUTION
WARNING
95