Electrolux EFLW417SIW Installation Instructions Manual page 10

10
Installation Instructions
Connecting drain and electrical
1. Verify the anti-siphon disc is in place.
2. Form a "U" shape on the end of the drain
hose with the hose pointed toward the drain.
Place the formed end in a laundry tub or a
standpipe and secure the drain hose with the
cable tie (provided in the enclosure package)
to the standpipe, inlet hose, laundry tub, etc.
so the hose does not pull out from the force
of the water.
NOTE
The standpipe inside diameter must be 1-1/4"
(3.2 cm) minimum. There must be an air gap
around the drain hose in the standpipe. A snug
hose fi t can cause a siphoning action.
IMPORTANT
Check to ensure the power is off at a circuit
breaker/fuse box before plugging the power
cord into an outlet.
3. Plug the power cord into a grounded outlet.
Grounding Grounding
type type wa wall ll
receptacle receptacle
4. Turn on the power at a circuit breaker/fuse
box.
5. Carefully slide the washer to its fi nal position.
Recheck for level and rock corners for stabil-
ity. Remove and discard door tape.
6. Read the Use & Care Guide provided with the
washer. It contains valuable and helpful infor-
mation that will save you time and money.
7. Run the washer through a complete cycle,
checking for water leaks and proper opera-
tion.
8. If you have any questions during initial op-
eration, please review the "Service Prevention
Checklist" in your Use & Care Guide before
calling for service.
9. Place these instructions in a location near the
washer for future reference.
NOTE
A wiring diagram and technical data sheet are
located under the washer top panel, on top of
the detergent dispenser housing.
Do not, under any circumstances, Do not, under any circumstances,
cut, remove, or bypass the cut, remove, or bypass the
grounding prong. grounding prong.
Po Power cord wer cord
with 3-prong with 3-prong
gr grounded plug ounded plug
CABLE TIE
ANTI-SIPHON
DISC