Bosch HBL84 Use And Care Manual page 18

2. Press Enter to accept the default 74:00 hours and start
Sabbath Mode. Or use the numeric keypad to enter the
desired Sabbath mode timer value. Timer values
between 0:01 and 74:00 can be entered.
Note: If no changes are made within 10 seconds,
Sabbath Mode auto starts.
3. Once Sabbath mode has begun, the display changes
to show the message "SABBATH ON".
4. After the Sabbath mode countdown reaches zero, the
oven displays the current time and the message
"SABBATH". No user input is accepted in this state. To
end the Sabbath Mode and return to normal function,
press the Oven Clear/Off touchpad.
Sabbath Mode on Double Ovens
Sabbath mode operates the same for the double oven as
for the single oven. To run Sabbath mode in both ovens,
Bake must be running in both ovens within the allowed
Sabbath temperature range. Sabbath mode can then be
started in both ovens by pressing and holding the Oven
Timer touchpad for 5 seconds.
There is a single timer for Sabbath mode. For double ovens
the Sabbath mode timer is shared by both ovens. The timer
English 16
value can be changed when it is blinking during Sabbath
mode setup.
Double ovens running the Sabbath mode appear on the
display with the countdown Sabbath mode timer in the
lower right corner.
Note:
-- Double ovens are capable of running Sabbath Mode
on both the upper and the lower oven, individually or
both at the same time.
-- The temperature in Sabbath Mode is 100° to 450° F.
-- The Sabbath mode timer can be set between 0:01 and
74 hours.
To edit the Sabbath Temperature:
While editing the temperature in Sabbath mode, there is no
feedback from the control. If an invalid temperature is set,
the oven will default back to the previous running
temperature.
Single Ovens
1. Press the Bake touchpad.
2. Enter the new desired set temperature.
3. Press Enter.
The oven will adjust its set temperature after a randomized
delay.
Double Ovens
1. Select the appropriate running cavity.
2. Press the Bake touchpad.
3. Enter the new desired set temperature.
4. Press Enter.