Setting The Output Level; Make System Settings; Setting The Type Of Batteries; Set The Automatic Power Saving Function - Tascam SD-20M Owner's Manual

Setting the output level

If sound distorts from an output destination device at maximum
output level, you can set this function to lower the output level
to stop the distortion.
1. Select the
OUTPUT LEVEL
press the MULTI JOG dial. (See "Menu operation procedures"
on page 14.)
The screen opens.
OUTPUT LEVEL
2. Turn the MULTI JOG dial to set the output level.
Options: (default) –
0dB -14dB
3. When finished, press the STOP/HOME [8] button to return
to the Home Screen.

Make system settings

You can change various settings on the
the device for your use conditions and other requirements. (See
"Menu operation procedures" on page 14.)

Setting the type of batteries

Use the item to set the type of batteries used.
BATTERY TYPE
This setting is used to show the amount of remaining battery
charge and determine if the unit has enough power for normal
operation.
Options: (alkaline, default),
ALKALI
hydride), (lithium)
LITHIUM

Set the automatic power saving function

Use the item to set the amount of time from
AUTO PWR SAVE
when the unit last operated or was used until the unit automat-
ically turns off.
Options: (unit does not automatically turn off ),
OFF
, , (default)
5min 10min 30min

Setting the backlight

Use to set the time until the backlight automati-
BACKLIGHT
cally turns off after the last operation.
Options: (turned off ),
OFF
, , (always on)
sec 30 sec ALWAYS

Adjusting the display contrast

Use to adjust the display contrast.
CONTRAST
Options: – (default:
1 20 5
item on the screen, and
MENU
(in 1dB increments)
screen to optimize
MENU
(nickel-metal
Ni-MH
3min
(default), ,
5 sec 10 sec 15
)
7 – Settings and Information

Viewing system information

The screen shows information about the unit's system
VERSION
firmware version.
1. Select the
VERSION
MULTI JOG dial. (See "Menu operation procedures" on page
14.)
Information about the current system firmware version is
shown on the
VERSION
2. When finished, press the STOP/HOME [8] button to return
to the Home Screen.
,
item on the screen, and press the
MENU
screen.
TASCAM SD-20M
35