Olympus DP30BW Instructions Manual page 12

Fig. 4
²
³
@
Fig. 5
9
When using a commercially available tripod
|
²
}The DP-TRAD tripod adapter is provided with two types of screws (2 each)
@
1. Insert the Philips screws ² into the DP-TRAD tripod adapter @ and, without
2. Tighten the Philips screws ² by inserting a Phillips screwdriver through the
3. Insert the tripod clamping screw into the tripod screw hole ƒ and tighten
³
ƒ
# Prepare a tripod that can withstand the camera head (approx.
Connecting the Interface Cable
# Be sure to turn off the PC before proceeding.
# Lay the interface cable out away from heat-generating sections such
and an Allen wrench. Use only the Phillips screws (x 2) with the DP30BW.
tilting the tripod adapter, place it in position in the insertion slot ³.
guide holes |.
the screw.
2.7 kg). Make sure that the legs of the tripod are fully extended.
Connect the connector @ on the other end of the interface cable that is
already connected to the PC to the connector ² on the camera head
and tighten the connector's lock screws ³. Check that the interface cable
will not slip out.
as the lamp housing of the microscope.