For Network Users (Dcp-310Cn Only); Network User's Guide Chapter Map; Restoring The Network Settings To Factory Default; For Network Users - Brother DCP-110C Quick Setup Manual

■ For Network Users (DCP-310CN only)

This section is for using the machine on a network. An administrator should set up the machine
using the following steps.

Network User's Guide Chapter Map

®
Windows 98/Me
®
Windows 2000/XP
®
Macintosh
OS2 Warp Server, LAN Server

Restoring the Network Settings to Factory Default

To restore all network settings of the internal Print/Scan server to factory default, please follow
the steps below.
1
Make sure the machine is not operating, then disconnect all the cables from the machine (except
power cable).
2
Press Menu.
3
▲ ▼
Press or
Press Set.
4
▲ ▼
Press or
Press Set.
5
▲
Press to select 1.Reset.
6
▲
Press again to select 1.Yes.
7
The machine will restart, re-connect cables once this is complete.
28
Peer-to-Peer
Peer-to-Peer
to select 3.LAN.
to select
0.Factory Reset.
TCP/IP Chapter 4 Network Printing from Windows
TCP/IP Chapter 4 Network Printing from Windows
TCP/IP Chapter 5 Network Printing from Macintosh
TCP/IP Chapter 4 Network Printing from Windows
®
®
®
®