General Information; Fuel; Boiler Installation - Worcester Greenstar Danesmoor External Regular ErP User Instructions

6

General information

WARNING:
▶ External equipment operating at 230 Volts
must not be serviced or repaired during
adverse weather conditions.
▶ Do not use pressure washers or steam
cleaners on this appliance or cabinet.
6.1

Fuel

This appliance is designed to use 28 second kerosene, no other
fuel must be used.
6.2

Boiler installation

Boiler location
WARNING: Boiler installation:
▶ This boiler must not be installed where
here is a potential for excessive ground
water coverage.
▶ Never allow the flue terminal or air inlet to
become obstructed by plants or any other
objects.
To prevent "wetting" it is recommended that the flue terminal
faces away from walls.
This boiler is only suitable for installing externally at a suitable
location onto a fixed, permanent, rigid surface capable of
supporting the boiler weight. Wood and tarmac hardstandings
are not recommended.
The boiler must be installed on a flat level surface to ensure that
condensate does not enter the primary heat exchanger.
The cabinet is not load bearing, and only provides weather
protection for the boiler inside.
There must be sufficient hard standing and access around the
boiler for servicing.
Greenstar Danesmoor External & External System – 6 720 813 726 (2014/09)
ErP ErP
600mm
BASE
2500mm
PLAN
VIEW
65mm
FRONT
600mm
50mm
PLAN
VIEW
FRONT
600mm
General information
45mm
10mm
9