3Com wl-602 Installation Manual page 4

5. Four LAN Status LEDs Blue
If the LED is on, the link between the port and the next piece of network equipment is OK. If the LED
is flashing, the link is OK and data is being transmitted or received. If the LED is off, nothing is
connected, the connected device is switched off, or there is a problem with the connection (refer the
'Problem Solving' section). The port will automatically adjust to the correct speed and duplex.
6. WPS LED Blue
When flashing indicates that the WPS function is active. The WPS function will operate for
approximately 2 minutes after the WPS mode has been activated.
The rear panel of the Router contains one WPS button, four LAN ports, one WAN port, one WiFi button, a
reset button and a power adapter socket
1. Wireless Antenna
The two external antenna should be placed in a 'V' position when initially installed. Note that there is
an internal antenna. In some installations it may be beneficial to move the router to ensure optimum
wireless range.
2. WPS Button
Press this button in for at least 3 seconds to start the WPS setup.
3. Ethernet Ports (4 ports)
Using suitable RJ-45 cables, you can connect your Router to a computer, or to any other piece of
equipment that has an Ethernet connection (for example, a hub or a switch). These ports have an
automatic MDI/MDIX feature, which means either straight-through or a crossover cable can be
used.
4